...
python3 fritzflash.py
This program will help you installing Gluon, a widely used Firmware for Freifunk networks, onto your AVM device.
You can always find the most current version of this script at https://www.github.com/freifunk-darmstadt/fritz-tools
It is strongly recommended to only connect your computer to the device you want to flash.
Try to disable all other connections (Ethernet, WiFi/WLAN, VMs) if detection fails.
Sometimes an unmanaged switch between your AVM device and your computer is helpfull.
Before we start, make sure you have assigned your PC a static IP Address in the Subnet of the device you want to flash.
The following example would be a completely fine option:
IP-Address: 192.168.178.2
Subnet: 255.255.255.0
Gateway: 192.168.178.1
DNS Servers: Leave blank
Once you're ready to flash, press enter, disconnect power from your AVM device and reconnect the power-supply.
Trying to autodiscover! Abort via Ctrl-c.
FritzBox found at 192.168.178.1
Autodiscovery succesful!
-> Device detected at 192.168.178.1.
Starting automatic image-selection!
-> Establishing connection to device!
--> Try 1 of 10
-> Automatic image-selection successful!
--> Will flash /home/freifunker/Downloads/fb4040_erstinstallation/firmware.bin
-> Establishing connection to device!
--> Try 1 of 10
-> Flash image
Writing Gluon image to your AVM device...
This process may take a lot of time.
First, the device will erase its current Operating System.
Next, the device will write the Gluon image to its memory.
The red Info LED will illuminate in this step. Don't worry, this is expected behavior.
Do *not* turn off the device!
We will tell you when your device has finished installing Gluon (this may take a while).
-> Image write successful
-> Performing reboot
== Congratulations! ==
Your device is now running Gluon.
It will restart and in 2-5 minutes you will be able to visit its config-mode.
Remember to reconfigure your interface to automatically obtain an IP-address!
You can reach config-mode by typing in http://192.168.1.1/ in your preferred Webbrowser.
Press any key to exit.
asdf
Wenn es nicht beim ersten mal klappt, einfach noch einmal versuchen.
abschliessende Einrichtung des Freifunk-Router
Jetzt kann der PC wieder auf DHCP bzw. eine IP 192.168.1.20 eingestellt werden und die Einrichtung wie üblich hier beschrieben vorgenommen werden.